top of page


  • Hardware: V2.2
  • Max voltage: 13S (60V)
  • Continuous Current: 150A , Max Current: 200A
  • Mosfets: NVMFS5C628NLs
  • LED button diameter:12mm, cable length: 250mm
  • PCB thickness:4 layers*3oz copper=12oz copper
  • PCB size: 40mm*32m

Enhanced Features:

    • High Side Switching -> Much safer to use with multiple ESCs and other devices.
    • In-rush current limiting.
      • RC delay network restricts inrush current to safe levels.
      • dV/dt is ~100V/s (This is considered VERY slow for power electronics. Fast would be 50,000,000V/s). At 6,000 uF output capacitance, this is an inrush current of 600mA.
    • Smart Power on/off
      • Roll-to-start. Has 12 second blanking timer after turn off. Can still be turned on by switch during this period.
      • Auto-turn-off. Will turn off automatically after 20 minutes. The output voltage must vary by at least 500mV within any three second interval to reset the turn-off timer.
      • Support momentary push button. Hold for 0.3s to turn on, 1s to turn off. Holding it down will cycle it on then off.
    • High power, 150A Continuous.
    • Very low idle power draw, ~300uA, will last months on battery.


    For more info vist 


    Anti spark Switch Smart Enhanced 200A for Electric Skateboard

    • We are Australian distrbuttor and supplyer in AU, we offer local support and warranty above and beyond the rest :)

    • We are 100% Australian Owend and Run out of Beutiful Sydney Australia, We handel all warranty and support localy and as swift as we can manage to ensure your up and riding your board and not down in the dumps, As AN Australian bussiness we hope to meet and exectided our obligations under ACCC Law and if you wish to inquire futher into our warranty policy pleaase check out our policy HERE